fluxcoil wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
==== Robotron EC1834 ====
IBM PC XT-compatible east german computer, https://sudonull.com/post/113859-Rare-Robotron-EC-1834-computer
  * CPU: 4,9152 MHz Intel-8086-compatible CPU K1810 WM86 / 5,25" floppy (2 sides, each 720kb)
  * 256kb RAM + 256kb card
  * OS: DCP 3.20 or 3.30, or MUTOS1834, alternatively CP/M-86, DOS or Windows 3.0)
  * K5504 20MB harddisk
  * ISA cards, no default connector as can be seen [[https://github.com/mgoegel/ec1834-troubleshooting/blob/main/docs/DE/ts-mainboard.md|here]]. If desoldering these, one could use these: https://www.buerklin.com/en/p/amp/pcb-connection-systems/6-5530843-5/57F748/?segment=b2c
  * K7229.25 monitor, broken?
    * connector: male
    * [[https://www.serdashop.com/MCE2HDMI|MCE2HDMI]] converter, I got that one
    * Or vga to sub9 adapter? Resoldering might be required: https://sudonull.com/post/113859-Rare-Robotron-EC-1834-computer
    * Or sub9 to VBS connection should work, according to https://mastodontech.de/@tagon/110808180911726114 . VBS (Video, Blanking and Syncs) = composite video
    * db9 to db15 cable might be enough: https://www.youtube.com/watch?v=_vh_SnveZVY
    * [[https://github.com/hoglet67/RGBtoHDMI/wiki/|selfbuild project, converts to HDMI]], [[https://www.sellmyretro.com/offer/details/62028|further rgb2hdmi device]], [[https://www.amazon.de/dp/B078ZDTLBJ/|further rgb2hdmi device]], [[https://gglabs.us/node/2284|CGA2RGBv2 device]]
  * K7033.10 COL graphics card
    * can do 32kHz vertical frequency, 29,58kHz horizontal frequency, 58.4-62.4Hz picture frequency
    * Connector: female
    * maximum resolution - 640x480, CGA- and EGA-compatible
  * OPS K3575.10 RAM expansion card
  * https://rechenwerk-halle.de/ - Rechenwerk Halle, Rene Meyer

==== MCE2HDMI ====
  * available [[https://www.serdashop.com/MCE2HDMI|here]]
  * https://github.com/hoglet67/RGBtoHDMI
  * https://github.com/hoglet67/RGBtoHDMI/wiki -- wiki
  * https://github.com/hoglet67/RGBtoHDMI/issues/357 - opened this issue
  * Potential next steps:
    * use an oszi or a USB uszi to check if the graphics card is handing out a proper signal. With the MCE2HDMI card, I see "something" which changes when I press keys. But no proper sync/picture.
    * replace the graphics card with a known good one (I don't have access to one)
    * strip down cards, check the dip switches position (haven't modified these so far)
    * Post to https://www.robotrontechnik.de/ board
fluxcoil wiki

User Tools

Site Tools

Page Tools
